Attention: This model (TH215) has "universal output socket" and is recommended for customers who are not in North America. This controller can control both temperature (heating or cooling) and humidity (humidifying or dehumidifying) at the same time. It has a two-line LED display, two output sockets, one sensor module, and one input power cord. The top display shows the measured temperature value, which can be displayed either in Celsius degrees or in Fahrenheit degrees. The bottom display shows the measured humidity value, which is expressed as percentage (%rh).
The left output socket is for heating/cooling device. The right output socket is for humidifier/dehumidifier.The sensor module contains both temperature and humidity sensors. This controller can be used in high relative humidity (>85%) and condensing environments, which are among the most challenging conditions for humidity controllers.
For example, when controlling the humidity of a curing fridge at temperatures below the dew point of the ambient environment, open the fridge door will cause water condense at the sensor. When controlling the humidity at a humidity level that is close to 100%, slight temperature drop may also cause condensation at the sensor.
Condensed water on the sensor can lead to unstable readings on most humidity sensors. This new controller is equipped with one of the most robust humidity sensors on the market. It can be fully recovered even if the sensor is wet.
0.1 °C (between -9.9 80 °C) 1 °C (between -40 -10 °C) 0.1 °F (between -9.999.9 °F) 1 °F (between -40 -10 °F, 100 176 °F). 15A, 120V or 240V AC. The controller can display the temperature unit in Celsius or Fahrenheit. Unlike the PID controllers we sell, this on/off controller will not hold the temperature as tight if the system has very slow and delayed response. Some temperature overshot is normal.Although both temperature and humidity output can handle up to 15Amp of power, the combined total power of the two channels are limited to 15A due to the limitation of input power cord. The input power plug is a US NEMA 5-15P plug.
Its output sockets will accept US, Australia, or European continental plug (CEE7/7). It will be delivered about 1-2 weeks to Canada, 3-4 weeks to other countries. The item "Plug-n-play Temperature and Humidity Controller (Intl' Model)" is in sale since Thursday, January 30, 2014. This item is in the category "Consumer Electronics\Surveillance & Smart Home Electronics\Other Smart Home Electronics".
The seller is "auberinstruments" and is located in Alpharetta, Georgia. This item can be shipped worldwide.